GM MDI Use the scroll buttons on the scan tool to navigate by way of the menu until you see the &quo

Tips on how to Reset the Check Engine Light on a 95 Tacoma OBD Scan Tool1Locate the diagnostic link connector (DLC) port near the base on the steering column. Plug the OBD scan tool into the DLC port, making sure the connection is secure. Be careful not to bend the pins on the DLC port.2Insert the key in to the ignition cylinder and turn the key to the "ACC/ON" car diagnostic software; position. Permit the scan tool to energy up and communicate together with the Tacoma's OBD personal computer.

Use the scroll buttons on the scan tool to navigate by way of the menu until you see the "Erase/Delete Codes" choice.3Select the "Erase/Delete Codes" choice and wait for the scan tool to return for the key menu. This may take some seconds to finish. Afterwards, unplug the scan tool and commence the Tacoma. Verify the instrument/warning light panel and make certain the Check Engine light is off.Manual Re-set4Open the hood on the Tacoma by pulling the hood release latch on the driver's side of your cabin. Locate the exterior latch close to the center of the hood and press it to raise the hood.

5Use a ratchet and socket to disconnect the negative terminal cable from the battery. Re-enter the vehicle and step on the brake pedal GM MDI. Hold the brake pedal for five to 10 seconds to discharge the remaining electricity inside the wiring program. This may also bring about the battery for the ECU's memory storage to be drained, subsequently causing the parameters for the Examine Engine light to temporarily disappear.6Allow the battery to stay disconnected for as much as an hour. Afterwards, reconnect the unfavorable terminal cable towards the battery and close the hood. The ECU will want some time to relearn details pertaining towards the overall performance and efficiency with the engine.